How to lubricate roller skate wheels?

Roller skate wheels take some upkeep to ensure that they continue to perform at a high level. To keep your wheels like new, it is recommended to clean and lubricate your wheels and bearings to ensure that your Roller skate continue to roll like the day that you bought them. Rollerblade recommends that you clean, rotate and lubricate your wheels whenever you see dirt accumulating or see one side of the wheels wearing down more than the other side.

How to lubricate rollerblade wheels?

Things You’ll Need

  • #4Allen key
  • Flathead screwdriver
  • Clean motor oil
  • Plastic container with lid
  • Water
  • Mild soap
  • Paper towel


Lubricating your roller skates wheels.

Step 1

Remove the bearings from your Rolle skates wheels. Loosen and remove the axle with the #4 Allen key, which will allow you to remove the wheel and bearings. If the bearings do not fall right out of the wheel, they can be pried out with a small flathead screwdriver.

Step 2
Place your bearings in a plastic container, and pour enough clean, conventional motor oil to cover the top of the bearings. While the bearings are soaking, rotate the wheels so that they wear evenly on both sides. Rotate the front wheels with the back, as well as flipping the wheels over from one side to the other. You can also clean the wheels by wiping them down with water and mild soap.

Step 3
Seal the lid on the plastic container and let the bearings soak overnight. This will remove the dirt particles that have built up in the bearings and also act as added lubricant to the bearings.

Step 4
Wipe the excess oil off the bearings with paper towel.

Step 5
Insert the bearings back into the wheel, and then place the entire wheel back onto the axle. Tighten the axle back into its original position with the #4 Allen key.

The original article from:

Written by Raven Inline Skates